Laminate Trimmer Replacement Parts

Search By Laminate Trimmer Model or Part Number

Same Day Shipping

Toll Free Support

Repair Help & Videos

Most Popular Laminate Trimmer Replacement Parts

Laminate Trimmer Power Cord

Part Number: 330072-98

71 Reviews

In Stock

$20.57

This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

Laminate Trimmer Ball Bearing

Part Number: 605040-65

3 Reviews

Factory Backorder

$5.95

This Ball Bearing is sealed on both sides. It is a genuine DeWalt replacement part and is sold individually.

Ball bearings are used to reduce friction between rotating parts..
The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction.
This reduces wear on the tool and allows it to run smoothly.

Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Laminate Trimmer Cord

Part Number: 3604460555

19 Reviews

In Stock

$11.06

This cord is a genuine OEM replacement part and is sold individually.
Power Cord Specifications:
2 Wires.
18 Gauge.
2 Prongs.
6-1/2 Feet Long.

It is constructed with thick insulation for long service life and a strong two-prong plug. This cord is compatible with the tools listed below. It can work for other applications and for other tools as well, but compatibility is not guaranteed.
Installation of this part requires the new cord wires be stripped and to fit correctly into the wire terminals.

Laminate Trimmer Carbon Brush Set

Part Number: CB408

12 Reviews

In Stock

$10.85

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box.

This brush set will fit the Makita tools listed at the bottom of the page.

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Laminate Trimmer Power Cord (8-foot)

Part Number: 664064-4

28 Reviews

In Stock

$20.22

This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually.
Replacing this power supply cord you will need a screwdriver.

• Remove the housing screws
• Remove the the housing
• Disconnect the old cord wires
• Remove the old power cord
• Secure the new cord in place
• Connect the wires
• Reassemble and test the new cord